Our present project is a 1941 house. We’re doing various reno’s around the house. We decided to remove the central brick chimney stack which vents the equally as old furnace (that’ll be another story). By doing this we can then utilise the space where the chimney stack once was on three floors. This space will be added to the upstairs bathroom, the family room on the main floor and into the kitchen in the basement suite. True to our form of being recyclers the bricks are being saved for a potential patio (they’re a solid terracotta brick). If we don’t use them somebody will and of course we’ll be posting them on here. For the removal we brought in a subcontractor as he also had the roofing skills to seal up the hole up top. (with matching T lock shingles – which are incidentally discontinued in small orders) We were going to run the new flu up the existing route (using a ‘b’ section – a double walled flu pipe). We then later decided that we would fit a high efficiency furnace (even higher than normal – which equates to 90%) which is then vented out the side wall thus allowing us to completely utilise the void left by the chimney. The removal took a day.
From the picture below you can see the exposed lath indicates how much we have regained in space in the family room and which also allows us to open up the doorway.
Like wise below we can see the extra space we will take back in the upstairs bathroom and also a cupboard on the landing.
…..and consequently in the basement (which is a tenanted suite) we can now take back the space next to the furnace where the chimney was.